Three Correct Usage Methods of Wireless Transceiver Module
The working frequency of the wireless transceiver module is 315MHz or 433MHz (there are other special frequencies), and the SAW resonator is used to stabilize the frequency, so the frequency stability is extremely high. When the ambient temperature changes between-25 and+85 degrees, the frequency drift is only 3ppm/ degree. It is especially suitable for wireless remote control and data transmission system. The frequency stability of acoustic resonator is second only to that of crystal, but the frequency stability and consistency of general LC oscillator are poor. Even if high-quality fine-tuning capacitors are used, it is difficult to ensure that the tuned frequency points will not shift due to temperature difference and vibration.After that, RF Module Not afraid of the future, dare to fight and fight, and won applause again and again in the market. https://www.hkulike.com/
So how to use the wireless transceiver module correctly? The following small series of Zhuoxin Technology introduces the following three methods.
1. It is used to build a wireless communication network with star topology.
It must be a multi-point star topology, and some special places need wireless communication. On the one hand, this kind of transmitting and receiving module is cheap, and the cost of forming a star topology is relatively low; On the other hand, the transmitting and receiving module can adopt modular design, which is small in size, convenient to use and easy to integrate. This transmitting and receiving module is very practical for wireless networks with low communication speed and close distance.
2. Used for wireless multi-channel (parallel) control
Such as complex remote control robots, some places need multi-channel control. One method is that the receiver module is directly connected to the decoder, and then connected to electronic components such as relays to drive the subsequent controlled objects; Another method is to connect the receiving module with the single chip microcomputer, and then connect the relay and other electronic components with the single chip microcomputer after data processing to drive the subsequent controlled objects. Usually, a pair of transmitting and receiving modules can realize six parallel wireless control at most. If the number of channels required is more than six, multiple pairs of transmitting and receiving modules can be used to work at the same time to meet the actual needs.
3. Used for universal serial port (C502B) wireless data transmission.
Usually, many control instruments and devices use serial port, and communication with these devices must meet the requirements of serial port. Some extraordinary places, industrial control sites. When it is necessary to use wireless transmission mode, the transmitting and receiving module mentioned in this paper can be naturally selected. However, it must be explained here that in order to adopt this communication method, the corresponding software must be compiled at the transmitter and receiver to realize the file format conversion, so as to achieve the purpose of wireless communication. If the communication system is full duplex, two pairs of transmitter and receiver modules can be used to work at the same time.
Of course, there are some precautions when using the wireless transceiver module. The transmitting module should be installed vertically on the edge of the motherboard, and should be more than 5mm away from the surrounding devices to avoid being affected by the distribution parameters. The transmission distance of wireless transceiver module is related to modulation signal frequency and amplitude, transmitting voltage and battery capacity, sensitivity of transmitting antenna and receiver, and receiving and transmitting environment.
